0261206794 1037360314 Bosch ME7.5 map pack – Audi S3 1.8 20V TURBO 210hp
0261206794SW1037360314CAL8N0906018J_0004This pack holds 97 maps of this exact software version, each with its X/Y axes and factor — ready to import into WinOLS. The full list is below.
Audi S3 1.8 20V TURBO 210hp · Bosch ME7.5
Also written: 0 261 206 794 · 1 037 360 314
More packs: Audi S3 · Bosch ME7.5
All 97 maps
The percentage beside a name: the share of the 137 Bosch ME7.5 packs that name it too.
Deactivations 27 maps
- Lambda Sensor (1=ON, 0=OFF)26 maps · 80%
- Speed limiters (switch)12%
Limiters 15 maps
- RPM Limiter5 maps · 96%
- RPM limiter (higher threshold)74%
- Maximum speed of vehicle3 maps · 68%
- RPM limiter (lower threshold)2 maps · 46%
- Idle engine speed f(ECT)4 maps · 22%
Spark Advance 13 maps
- Spark Advance base map2 maps · 98%
- Spark advance during cranking62%
- Minimum Spark Advance3 maps · 38%
- Limiter of knocking sensor4 maps · 35%
- Spark advance correction f(Trq)2 maps · 25%
- Spark advance correction f(Air_T)24%
Air Control 12 maps
- Requested engine load97%
- Throttle valve - operating angle97%
- Airflow mass through throttle valve93%
- Reference of maximum throttle valve angle86%
- Threshold of end limitation on throttle valve angle77%
- Throttle valve f(Accelerator pedal)72%
- Exhaust gas temperature3 maps · 60%
- MAF scaling38%
- MAF sensor offset32%
- MAF23%
Engine Torque 12 maps
- Optimal engine torque98%
- Torque request during take off condition84%
- Torque monitoring9 maps · 31%
- Torque request during take off condition - Reverse Gear26%
Turbo System 11 maps
- Slow incremental factor of turbo pressure84%
- Fast reduction factor of turbo pressure81%
- Limiter of Turbo pressure80%
- Correction of slow incremental factor of turbo pressure72%
- Linearization of impulsive turbo pressure59%
- Limiter of steady turbo pressure53%
- Limiter of impulsive turbo pressure50%
- Turbo pressure41%
- Limiter of differential Turbo pressure f(APS)36%
- Variable geometry (VGT) or wastegate (WG) control2 maps · 31%
Injection System 7 maps
- Requested Lambda96%
- Phase of injection2 maps · 74%
- Injection at partial load66%
- Injection correction61%
- Injection correction f(Air_T)31%
- Conversion of relative fuel mass into effective injection time15%
How this pack differs from other Bosch ME7.5 packs
Named here, but by under half of the 137 Bosch ME7.5 packs (14 of 17, the rarest first):
- Speed limiters (switch) 12%
- Conversion of relative fuel mass into effective injection time 15%
- Idle engine speed f(ECT) 22%
- MAF 23%
- Spark advance correction f(Air_T) 24%
- Spark advance correction f(Trq) 25%
- Torque request during take off condition - Reverse Gear 26%
- Injection correction f(Air_T) 31%
- Torque monitoring 31%
- Variable geometry (VGT) or wastegate (WG) control 31%
- MAF sensor offset 32%
- Limiter of knocking sensor 35%
- Limiter of differential Turbo pressure f(APS) 36%
- MAF scaling 38%
Named by at least half of them, but not by this pack:
- Lambda for component protection 73%
- Optimal Spark Advance 66%
- Wastegate Duty Cycle 62%
97 maps against the Bosch ME7.5 median
The 137 Bosch ME7.5 packs name 12 to 108 maps, median 49; 93% of them name fewer than this one.
| Category | This pack | Median pack |
|---|---|---|
| Deactivations | 27 | 4 |
| Limiters | 15 | 8 |
| Spark Advance | 13 | 5 |
| Air Control | 12 | 8 |
| Engine Torque | 12 | 4 |
| Turbo System | 11 | 11 |
| Injection System | 7 | 6 |
Other SW versions on HW 0261206794
3 SW versions sit on this HW in the archive, 5 files in all: Audi S3 (4), Volkswagen NEW Beetle (1). The last column shows which have a map pack.
| SW | Listed for | Map pack |
|---|---|---|
| 1037360154 | Audi S3 1.8 20V TURBO 210hp | none listed |
| 1037360284 | Audi S3 1.8 20V TURBO 210hp | none listed |
Map definitions only — no tuned values; the pack fits this software version only. Original read only (no full backup or EEPROM). A digital file: all sales are final — no refunds.