80A906259A_0003 Siemens SIMOS 18.4 map pack – Audi Q5 2.0 252hp
CAL
80A906259A_0003Spark Advance117Engine Torque114Air Control47Limiters29Turbo System26Rail12Injection System8Deactivations3
This pack holds 356 maps of this exact software version, each with its X/Y axes and factor — ready to import into WinOLS. The full list is below.
Audi Q5 2.0 252hp · Siemens SIMOS 18.4
More packs: Audi Q5 · Siemens SIMOS 18.4
All 356 maps
Spark Advance 117 maps
- Limiter of knocking sensor8 maps
- Minimum Spark Advance32 maps
- Optimal Spark Advance37 maps
- Spark Advance base map38 maps
- Spark advance correction f(Air_T)
- Spark Advance correction in function of high ECT and IAT
Engine Torque 114 maps
- Calculated engine torque
- Engine torque correction6 maps
- Limiter of Maximum torque7 maps
- Maximum engine torque correction f(ECT_T)10 maps
- Maximum engine torque correction f(IAT_T)5 maps
- Maximum torque limiter f(gear)31 maps
- Optimal engine torque24 maps
- Torque limiter for clutch protection7 maps
- Torque request during standard condition23 maps
Air Control 47 maps
- Airflow mass through throttle valve
- Cylinder head temperature4 maps
- Engine load limiter4 maps
- Exhaust gas temperature4 maps
- Manual Setpoint MAP
- MAP sensor maximum voltage
- Maximum allowable exhaust gas temperature for spark retard control
- Maximum MAF sensor
- Maximum MAP sensor
- Minimum MAF sensor
- Reference of maximum throttle valve angle
- Requested engine load24 maps
- Threshold of end limitation on throttle valve angle2 maps
- Throttle valve
Limiters 29 maps
- Maximum speed of vehicle6 maps
- RPM Limiter17 maps
- RPM limiter (higher threshold)3 maps
- RPM limiter in Neutral3 maps
Turbo System 26 maps
- Boost pressure deviation for basic charge air pressure too low
- Correction of impulsive turbo pressure f(IAT)
- Limiter of impulsive turbo pressure2 maps
- Limiter of Turbo pressure9 maps
- Linearization of impulsive turbo pressure2 maps
- Maximum turbocharger speed2 maps
- Maximum turbocharger temperature
- Minimum pressure difference for basic charge air pressure too high
- Minimum pressure difference for basic charge air pressure too low
- Temperature difference to activate turbine overheating protection
- Threshold for turbocharger speed reduction
- Wastegate Duty Cycle4 maps
Rail 12 maps
- Rail pressure12 maps
Injection System 8 maps
- Injection at full load2 maps
- Injection base map2 maps
- Limiter of Lambda A
- Limiter of Lambda B
- Requested Lambda2 maps
Deactivations 3 maps
- Deactivation turbocharger protection (1=ON, 0=OFF)
- Lambda Sensor (1=ON, 0=OFF)2 maps
356 maps against the Siemens SIMOS 18.4 median
The archive has only 2 Siemens SIMOS 18.4 packs, with 356 to 357 maps.
Map definitions only — no tuned values; the pack fits this software version only. Original read only (no full backup or EEPROM). A digital file: all sales are final — no refunds.